Hot Tub Heater Sensor Temperature Sensor with Box End Connectors 6600-167

$49.98


Product Description

Hot Tub Replacement Parts Heater Sensor Temperature Sensor with Box End Connectors 12 FT 6600-167

Comes with  6540-228 Oring

Used on these Sundance Spas:

  • 2012+ Aspen
  • 2005+ 880 Systems
  • 1997-2005 850 Systems. 400,600,600-S,750, 800 and 850 Systems.
  • 1992 Suncoast, 4/96-4/98 Suntub SV/DV Systems.
  • 1997+ 850, 880 Systems
  • Replaces #6600-138 and 6600-105(not shown). 
  • Interchangeable with 6600-182 sensor (stainless steel) with box end connectors.

For Inground Spas (spas with remote equipment with no skirt) see 6600-169

Used on the following Jacuzzi models:

  • 2002+ J-300 LCD Series
  • 2002-2003 J-350, J-360, J-380
  • 2004-2006 J-355, J-365, J-375, J-385
  • All 2005-2009 J-400 Models

Location of Temp Sensor: The Temp Sensors are located in the filter compartment on the side. They are unscrewed from the inside of the tub and the wire is fed through a tube into the equipment compartment. Follow the wire to the PC Board. To feed the new sensor, we usually drain the tub below the hole and pull the old sensor out a couple of feet into the tub, cutting the old sensor head off, we tie on the new sensor (connector end) to the old wire and pull the wire through into the equipment compartment.
Diagnostic and Installation: The connectors on the Temp Sensor are attached to a pc board connector that is located on the PC Board (usually at the top). See these instructions for Diagnostic and Installation:http://www.spaandpoolsource.com/sundancespastemperaturesensordiagnostic.aspx 

Please note: The color code on the wires have no significance, you can hook the wires up either way.
These sensors are interchangeable with the 6600-166 except for the end connector which does not connect into the 6600-167 harness. (would have to strip wires back and wire nut together.)